Welcome to Solid State Guitar Amp Forum | DIY Guitar Amplifiers. Please login or sign up.

November 13, 2024, 04:17:02 AM

Login with username, password and session length

Recent Posts

 

my oscilloscope

Started by saturated, April 15, 2023, 12:41:15 PM

Previous topic - Next topic

saturated

did not power on
found an open fuse
replaced fuse
put on dbt looked good
powered on but has no trace

crt is glowing a little but not much

You cannot view this attachment.

the slide switches are extremely stubborn

You cannot view this attachment.

you practically need a hammer and chisel to move them

 :)

I am aware there are crazy high voltages in these things so I havent fooled with it  :) 
I ask stupid questions
and make stupid mistakes

criticism, critique, derision, flaming, verbal abuse welcome

Loudthud

With the Sweep in NORMAL mode, there won't be a sweep unless you get a trigger somehow.

With EXT trigger source, you won't get a sweep unless you connect a signal to the External Trigger Input and adjust the trigger level control to get a trigger.

A drop or two of contact cleaner in each of those switches will free them up. Don't touch the end of the CRT tube shown in the picture.

saturated

hello everybody i think i want to try to get a trace on this device by (with your assistance) checking the power supply

obviously i (we) want to steer clear of high voltage areas

the same pics of the schematic are all over the net

You cannot view this attachment.

You cannot view this attachment.

You cannot view this attachment.

You cannot view this attachment.

thanks for your help meanwhile i am going to look for some (low) voltages to check

I ask stupid questions
and make stupid mistakes

criticism, critique, derision, flaming, verbal abuse welcome

Tassieviking

Do you have any wall warts with AC output ?
A nice small 9v AC would be a good test to do.
The older heavy DC ones usually have a transformer in them, you could test the DC voltage on AC and look for a ripple.
There are no stupid questions.
There are only stupid mistakes.

saturated

thank you sir that is an excellent suggestion

today I decided to look at this thing...todays goal was to be able to find something on the device then locate it on the schematic...or vice versa.

I was able to locate the two (bridge rectifiers)? and then test the voltage at point T (white wire) and I got 193v. (supposed to be 185v so I guess that is good)

one thing i noticed was the two rectangular resistors next to the diodes were pretty warm maybe that is normal but ones elsewhere were room temp.



You cannot view this attachment.

there is a voltage between d408 and d410 supposed to be 19v but i cant find a place to put my probe to test.
I ask stupid questions
and make stupid mistakes

criticism, critique, derision, flaming, verbal abuse welcome

Tassieviking

Those wirewound resistors are 5 watt and 10 watt for a reason, so they will get hot.
There are no stupid questions.
There are only stupid mistakes.