Also, charity type thrift stores or youth drop-in centres would probably appreciate it.
30% off all Honey Amp kits, check it out at https://store.ssguitar.com !
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.Show posts Menu
Quote from: saturated on May 02, 2023, 10:55:03 AMI have read that yellow and red are posYou are correct, that is the colour coding Peavey uses. The red dots on the speaker baskets are the + terminal. (that means one spkr in pic is wired wrong polarity)
and blue and black are neg...
but i can not find any markings on the speakers or terminal
Quote from: saturated on April 15, 2023, 12:00:41 PM...hooked everything up..put my multimeter on each side of the resistor...8.05v....dang itOne end of the resistor needs to go to ground and would measure 0 volts.
Quote from: saturated on April 11, 2023, 08:45:27 PMglad to see you recommend using mouser or digikey....was tempted to go elsewhere.Any kind of shop supplies or tools you might need. Solder, solder wick, heatshrink, test clips, pliers, cutters, etc.
if there is anything else I should get from there let me know I hate to spend $7.99 on a $3 order.
Quote from: saturated on April 11, 2023, 09:30:54 PMresistance across C58 about 3.5kohmNo shorts or excess load on the +9V rail indicated. Might have been that just the regulator went bad.
Quote from: FleshOnGear on April 09, 2023, 03:21:56 PMUsing simulations, I've figured that I can get roughly 10x as much wattage at 5kHz if the output impedance of the power amp is about 12 ohms, which is about twice as loud as with pure voltage feedback.I'm not sure what you are comparing to here, 10x more power than what?