Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => Amplifier Discussion => Topic started by: casarete on January 18, 2017, 09:02:01 AM
Hello to all,
sorry if I intrude, but I wanted to ask your advice because I have a problem with my VOX AC30SS ..
I have a cable connection problem of VIBRATO tab, I do not understand how to connect and restore the transformer wires ..
You can help you understand how to connect them?
I hope he was not too pushy, eventually, I apologize and I open new thread.
photo:
https://www.flickr.com/photos/132367757@N08/31972016600/in/dateposted-public/
https://www.flickr.com/photos/132367757@N08/32198731352/in/dateposted-public/
https://www.flickr.com/photos/132367757@N08/32228864471/in/dateposted-public/
https://www.flickr.com/photos/132367757@N08/32198698972/in/dateposted-public/
Thank you in advance for your response and the help
This is the official schematic, use it to find where your loose wire comes from, and find where it should go.
Very poor scan, but almost readable; for muddy values ask here and we might guess them.
(http://www.korguk.com/voxcircuits/circuits/ac30ss.jpg)
NOTE: I saw some terrible soldered joints in some of your pictures, I suggest a Tech helps you identify wiring and properly solder whatever is needed; as seen that amplifier is a fire hazard.