Hello good people. Me again with my pathfinder voxy! After all rumble with my ear and brain wracking, i found that factory set up of mentioned "monster" is all i need.. But what about reverb, and spring one of course??? Not to mention that i draw pcb layout of Phat Verb, but... Stand alone unit which is greater than amp? Forget, unfortunately... Idea is to insert spring reverb section of session rockette 30, but with preserving that sound... Many things make me confucing:
First.. This one ic spring reverb (tl072), is the best sounding reverb i`ve heard... I have read Rod Elliot article, and because of that i amazed how Stewart Ward achieve that.. Strong way driving 190ohm impedance tank with single (ok, dual) op amp ..
Because of that my plan is to add that reverb drive and recovery to my pathfinder... Is it possible and where would be insert point... After tone stack or master volume or.. ? And which modification i must plan? Suspect on gain values...
Thanks in advance!
Schematic and sound:
First.. This one ic spring reverb (tl072), is the best sounding reverb i`ve heard... I have read Rod Elliot article, and because of that i amazed how Stewart Ward achieve that.. Strong way driving 190ohm impedance tank with single (ok, dual) op amp ..
Because of that my plan is to add that reverb drive and recovery to my pathfinder... Is it possible and where would be insert point... After tone stack or master volume or.. ? And which modification i must plan? Suspect on gain values...
Thanks in advance!
Schematic and sound: