Forum upgraded to SMF 2.1.2!
Started by cin, December 13, 2021, 07:36:32 PM
Quote from: cin on January 15, 2022, 07:16:50 PMThe IN is clean, the OUT is dirty.So I pulled out the tank and took some measurements inside, the signal wires going into the IN coil is clean, the signal wire coming out of the OUT coil is dirty. The OUT coil does look like it may have overheated, the tape is discoloured in one spot. Is that a thing? Can a small coil overheat if it's overstimulated? Would that indicate the amp was shaken vigorously while On?So I'm guessing I'm stuck replacing the whole tank, it's all pretty much riveted together...THANKS GANG!
Quote from: phatt on January 15, 2022, 08:38:23 PMYou said the tank was wired in reverse,,,,,,,,,Well that may well have overheated the coil. 8|If you suspect the tank is the issue then disconnect the pickup cable and short the pickup end.
Quote from: cin on January 15, 2022, 07:16:50 PMThe IN is clean, the OUT is dirty.