Solid State Guitar Amp Forum | DIY Guitar Amplifiers
Solid State Amplifiers => Amplifier Discussion => Topic started by: monfi on July 28, 2017, 09:11:26 AM
Hello, if I wanna sobstitute power section of this schematic,with a IC poweramp, what part of circuit i've to "remove"? (I not think is all things put after R10)
tnx in advance ;)
Yes R10 is the power amplifier input.
Phil.
:) :dbtu:tnx
ThereĀ“s a couple details to take care of:
1) that amplifier is a single supply (+46V) type, any chipamp you use will also need to be used in a single supply mode, some datasheets suggest one.
Most are dual supply.
2) being single supply, it needs capacitor coupled input *and* output.
3)an LM3886 would be happy with a +46V supply and will last forever; a TDA2050 is just on the edge, will work properly but heat sink it well just in case.
:tu: thank you very much